![]() Verify that the Mac address appears in the list box.Enter the MAC address of the network interface ( see instructions below) you want related to the public IP.You will need to specify the MAC address of the relevant device network interface, which can be hooked up to an Ethernet port or by Wireless connection. This allows you to specify the mac address of the specific device on your local network that should receive the public IP (generally a router connected via an Ethernet cable). IP Passthrough on the Cisco DPC3848V can only be set by MAC Address. If the 3rd party device is connected prior to setting up IP Passthrough then you may be required to power cycle your equipment to complete the process. ![]() Default Password: the serial number printed on your modem.Enter the Gateway IP "192.168.0.1" in your web browser's address bar.Select either the MAC or Port IP Passthrough Mode and follow the specific steps below: MAC Address Mode: This mode allows you to specify the mac address of the specific device on your local network that should receive the public IP (generally a router connected via an ethernet cable). Contact Shaw customer support to confirm the availability of a second IP address, then follow the setup instructions outlined below.īefore you plug in your 3rd party router, follow these instructions: Enable IP Passthrough via the on/off toggle button. The automatic availability of multiple dynamic addresses depends on your Shaw Internet service package. To use IP Passthrough, you'll need to ensure that you have a second dynamic IP address available for your modem.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |